RevoluzionAutomotive
All guides

Sizing & thread identification

How to measure AN thread size with a caliper

Measure the OD, subtract the flare, and read the dash size off a chart.

Video walkthrough coming soon

You cannot identify an AN fitting by measuring the outside of the nut. The nut is a hex; you need the thread diameter.

Measuring with a caliper

  • Measure across the threads (the major diameter), not across the hex flats.
  • Measure on a clean, undamaged section of thread — a burred first thread reads small.
  • Compare against the table. A reading of about 9/16" (14.3 mm) is AN-6; 3/4" (19.0 mm) is AN-8.
  • If your reading lands between two sizes, the thread is probably damaged or you are on a tapered NPT thread.

A thread pitch gauge settles it faster

For a few ringgit a pitch gauge removes all doubt, especially when someone has already fitted a non-standard adapter to the part you are replacing.

The shortcut that works most of the time

If the hose is original and you are replacing a hose end, the hose bore gives you the dash size directly. Measure the inside diameter of the hose with the end cut off: 3/8" bore is AN-6.

Next guide

AN fittings explained: what the dash numbers actually mean