RevoluzionAutomotive
All guides

Installation

How to assemble an AN hose end without leaks

Cut square, deburr, lubricate, seat, torque — the steps that actually matter.

The short version

  • Cut the hose square. A ragged cut is the single most common cause of a leak.
  • Blow out the liner after cutting — swarf inside a fuel line ends up in an injector.
  • Hand-tight, then wrench. Over-torquing a 37° flare distorts the sealing face.

Video walkthrough coming soon

Almost every AN leak traces back to the cut. Get that right and the rest is straightforward.

1. Cut the hose square

Use a sharp cut-off wheel or a proper hose saw, not side cutters. Wrap the cut in tape first so the braid does not fray. A ragged or angled cut means the hose end never seats fully.

2. Blow the liner out

Swarf left inside a fuel or oil line travels to the injectors or the bearings. Blow through with compressed air, in the direction of flow.

3. Lubricate, do not force

A little assembly lubricant or clean oil on the hose end threads and barb. Never use grease on a brake line component.

4. Insert fully, then tighten

Thread the hose end on until it is fully seated — on most designs there is a visible gap that closes. Hand-tight first so the threads start square, then wrench.

5. Torque it properly

Follow the fitting manufacturer's torque figure for the size you are using. The old "hand tight plus a quarter turn" field rule is a fallback when you have no figure, not a target. Over-torquing distorts the 37° flare and creates a leak that gets worse the harder you try to fix it.

6. Support the hose

Clamp the hose every 200–300 mm and at any point where it passes near a heat source or a sharp edge. An unsupported hose fatigues at the fitting — and that is where it will eventually crack.

7. Pressure-test before you drive

Run the pump and check every joint with the engine cold, then again hot. A dry paper towel wrapped around each joint finds a weep that you cannot see.

Next guide

AN fittings explained: what the dash numbers actually mean