RevoluzionAutomotive
All guides

Hose & hose ends

Hose end styles: swivel, cutter, crimp, screw-on and push-lock

Which end goes with which hose, and when swivel is worth the money.

Video walkthrough coming soon

StyleHow it attachesReusable?Notes
SwivelThreaded nut spins on the hoseYesLets you aim the fitting after tightening — worth the extra cost on anything hard to reach
ForgedOne-piece forged bodyYesStronger than a brazed two-piece; heavier
CutterCuts into the hose outer when tightenedYesOnly for rubber hose. One-shot — do not reuse on a different hose
CrimpMachine-crimped collarNoThe OEM-style option; needs a crimper or a shop
Screw-on / reusableThreads into the hose boreYesField-serviceable; slower to assemble
Push-lockBarb pushed into the hoseYesLow pressure only
Snap-lockBarb with a retaining clipYesQuick to assemble, still low pressure

When swivel is worth it

If the fitting has to be clocked to a specific angle — a fuel rail inlet, a regulator port, anything tucked behind an engine mount — buy swivel. With a non-swivel end you torque the fitting to seal the flare and then discover the hose points the wrong way.

Do not reuse a cutter-style end on a different hose

The cutter deforms to the hose it was tightened onto. Moving it to a new hose leaves you relying on a groove cut to a different diameter.

Next guide

AN fittings explained: what the dash numbers actually mean