RevoluzionAutomotive
All guides

Installation

Finding a fuel or oil leak safely

How to pressure-test and trace a weep without creating a fire risk.

Video walkthrough coming soon

Fuel and oil leaks are a fire risk first and a mess second. Treat the search accordingly.

  • Cold engine only for the first check. Never hunt a fuel leak on a hot exhaust manifold.
  • Wipe every joint dry, then run the pump without starting the engine and watch.
  • Wrap a dry paper towel around each joint — a weep too small to see will wick into the paper.
  • Follow the highest wet point. Fluid runs down, so the lowest drip is rarely the source.
  • Check the flare before the thread. A leak at the thread on an AN joint usually means a damaged or misaligned flare, not a loose nut.

If you cannot find it

Stop adding torque. Repeated tightening of a leaking AN joint distorts the seating face and turns a five-ringgit flare into a replacement hose. Take the joint apart and look at the flare with a light — a witness mark that does not run all the way round tells you the two faces were never concentric.

Next guide

AN fittings explained: what the dash numbers actually mean