Fuel system
E85 and ethanol: what it does to your fuel system
Which rubbers and plastics survive alcohol, and what to change before switching.
The short version
- PTFE-lined hose is the safe choice for ethanol blends.
- Standard rubber hose degrades from the inside — you cannot see it until it fails.
- Aluminium is fine for ethanol; bare mild steel is not.
Video walkthrough coming soon
Ethanol is not a problem for the right materials and a slow failure for the wrong ones.
- PTFE-lined hose is inert to any ethanol blend. This is the safe choice.
- Standard rubber hose degrades from the inside. You cannot see it. The first symptom is usually a blocked filter or a leaking line, months later.
- Aluminium is fine with ethanol. Bare mild steel is not — it corrodes from the water that ethanol absorbs.
In Malaysia
E10 is widely available; E85 is not, outside a small number of stations. If you are building for E10 compatibility you are already covered by normal quality hose and PTFE. If you plan to run high ethanol content, build the whole system for it from the start rather than upgrading piece by piece.
Heat is the other half of the problem
In a tropical engine bay, fuel lines routed near the exhaust or across the top of the engine suffer vapour lock long before they fail. Route away from heat first, insulate second.
Next guide
AN fittings explained: what the dash numbers actually mean
