Hose & hose ends
Choosing hose: PTFE, rubber, push-lock or over-braid
What each hose type is for, and which hose end it needs.
The short version
- PTFE (Teflon) liner: brake, power steering, high heat, and any alcohol fuel.
- Rubber / synthetic CPE: general fuel, oil and coolant lines.
- Push-lock: low pressure return lines only — never fuel injection pressure.
- Over-braid: a protective sleeve over an existing hose, not a hose on its own.
Video walkthrough coming soon
Hose and hose end must match. A PTFE hose end on a rubber hose will not seal, no matter how tight it is.
| Hose | Seals | Use it for | Needs |
|---|---|---|---|
| PTFE, stainless braid | PTFE liner | Brakes, power steering, alcohol fuels, high heat | PTFE-specific hose ends (olive + ferrule) |
| Rubber / synthetic CPE, braid | Synthetic rubber | Pump fuel, oil, coolant | Cutter, crimp or reusable hose ends |
| Push-lock | Rubber | Low-pressure return and vent lines only | Push-lock hose ends, no clamp needed |
| Over-braid sleeve | — | Protecting an existing hose from abrasion and heat | Nothing — it is a sleeve, not a hose |
PTFE is the safe default for anything aggressive
PTFE is inert to ethanol, methanol, brake fluid and most solvents, and it takes far more heat than rubber. The trade-off is that it is stiffer, it does not like tight bend radii, and it needs its own hose ends — the liner will collapse if you use a standard rubber-hose end on it.
Push-lock is not a fuel injection hose
Push-lock is convenient and perfectly good for a low-pressure return or a catch-tank breather. It is not rated for injection pressure. If the line sees pump pressure, it needs a proper hose end.
Next guide
AN fittings explained: what the dash numbers actually mean
