RevoluzionAutomotive
All guides

Brake system

Brake lines: what you can do yourself, and what you cannot

Why brakes are a different risk category and when to have lines made professionally.

The short version

  • A brake line failure is not a breakdown — it is a loss of stopping power.
  • Use PTFE-lined hose for braided brake lines; rubber is not rated for brake fluid.
  • If the car is road-registered, check what your local authority allows before modifying brake lines.

Video walkthrough coming soon

A brake line failure is not a breakdown. It is a loss of stopping power, often at the worst possible moment. This is the one system where "I had a go" is not an acceptable outcome.

What you can reasonably do yourself

  • Replace a flexible line with a correctly specified braided PTFE line.
  • Fit adapters to an existing, unmodified hard line.
  • Bleed the system properly afterwards — air in a brake line is as dangerous as a leak.

What you should not

  • Make up your own hard lines without a proper flaring tool and gauge.
  • Use rubber hose for brake fluid. It is not rated for it.
  • Reuse a crush washer or a banjo bolt more than once.
  • Mix fitting materials that will corrode against each other.

Legal position

If the vehicle is road-registered in Malaysia, check what your inspecting authority allows before modifying brake lines. A modification that passes a visual inspection may still fail a roadworthiness check, and an insurance assessor will look closely at brake work after a collision.

If you are not certain, stop

Have the lines made professionally, or buy pre-assembled lines for your model. The cost of a made-up set is small next to the cost of getting it wrong.

Next guide

AN fittings explained: what the dash numbers actually mean