RevoluzionAutomotive
All guides

Hose & hose ends

45°, 90°, 120°, 150° or 180°: picking a bent hose end

How to choose the bend that routes cleanly without kinking the hose.

Video walkthrough coming soon

Bent hose ends exist so the hose leaves the fitting in a direction that does not kink it. Pick the angle from the routing, not from what is in stock.

  • Straight — the hose runs directly away from the port. Only use it when there is clear space behind.
  • 45° — a gentle turn. Common on fuel rails and regulator inlets.
  • 90° — the workhorse. Turns the hose along a chassis rail, or out of a port that faces a bulkhead.
  • 120° / 150° — for routing back alongside a component you cannot move.
  • 180° — doubles the hose back. Use it when the hose must return parallel to the port it just left.

Check the bend radius, not just the angle

A 90° end solves the direction but the hose still has a minimum bend radius. If the run from the fitting to the next clamp is shorter than that radius, the hose kinks internally and the liner collapses — which shows up later as a restricted flow you cannot find.

Next guide

AN fittings explained: what the dash numbers actually mean