RevoluzionAutomotive
All guides

Sizing & thread identification

AN vs JIC vs NPT: which one is on my car?

How to identify the port you are looking at before you buy the wrong adapter.

The short version

  • 37° flare, straight thread = AN or JIC.
  • 45° flare = SAE (older American plumbing).
  • Tapered thread that seals with tape or paste = NPT.
  • Flat face with an O-ring = ORB / metric O-ring boss.

Video walkthrough coming soon

Before buying any adapter, identify the port you are adapting to. Four visual checks get you there without a thread gauge.

1. Look at the sealing face

  • A cone inside the port (37° or 45°) — this is a flare fitting. AN or JIC if 37°, SAE if 45°.
  • A flat face with a counterbore and an O-ring — this is ORB or a metric O-ring boss. The O-ring does the sealing.
  • A plain tapered hole with no seat — NPT. It seals on the threads.
  • A flat face with a bonded washer — typical of banjo fittings and some DIN ports.

2. Check whether the thread is tapered

Run a fingernail along the crest. On NPT the thread depth changes from one end to the other; on AN and ORB it is constant. A tapered thread is the clearest single tell.

3. Count threads per inch if it is close

A thread pitch gauge is a few ringgit and settles it immediately. Common sizes are in the table on the sizing guide.

4. Know your car's origin

Japanese vehicles — which is most of what is built in Malaysia — mix JIS metric and NPT-style port threads depending on year and component. Toyota, Nissan and Honda fuel and oil ports are often metric straight thread with an O-ring, not NPT. Buying an "AN to NPT" adapter for a metric port wastes an order.

Next guide

AN fittings explained: what the dash numbers actually mean